Logiciel

When downloading this software, de Wijs is not responsible for any problems or costs caused by using this software. If there are errors on this site we are willing to correct these.

De Wijs products:

2017
Configuration program for 10-slide and 21-slide
rotary viewers which are equiped with an Arduino based
control board; 17-02-PCB_baseboard

Rotary_config 1.0

Firmware version 1.1 and update tool

2016-2018

Disk images for the controlling the digital 3D viewer through the Raspberry pi.

The Download requires unzip to extract the file.
Raspbian Wheezy and Pi-presents 1.3
Minimum of 8 GB SD card required.
This compilation holds the standard software of operating system Raspbian and Pipresents
Shows are to be configured using the Pipresents interface.
The screenshot below shows the raspbian Wheezy / pipresents interface.

Image works only on the Raspberry 2 (2014 on pcb) 4GB
Disk image Raspberry pi compilation 1.1 Raspbian Wheezy, pipresents 1.3.1-a (2016)

Image works on the Raspberry pi 2 and 3B, 8GB
Disk image Raspberry pi compilation 1.1 Raspbian Jessie, pipresents 1.35-c (2018)

Image works on the Raspberry pi 2, 3B and 4, 16GB
DON'T use this image if you don't have the switch for the default display on the Raspberry pi.
This is a PCB for the GPIO with a sepperate slide switch. Without this switch, it will alway's start in display 'safe mode'.
This image requires Raspberry pi 4 with bios 1.2! higher versions not supported.
Disk image Raspberry pi compilation 1.0 Raspbian Buster, pipresents 1.35-c (2020)

Use Win32DiskImager or another program to backup or restore the image of your card.
Use this manual how to make a copy or restore of a SD card image.

2014
External control of the rotary viewer with sound escort
for each slide. The software runs on a Windows 98-Win8
machine and is connected through the parallel port to
the viewer. A licence of 150 Euro's is required to run
the software completely.